Normally we are using BRF+ for support team determination using SAP Component, but also we can use the category id for the support team determination via BRF+.
Below step will hep to configure the BRF+ using category id.
Pre-requisite:
Test Management configuration.
Incident Management configuration
Version:
SAP Solution Manager 7.1 SP11 System used for below screen shot capture and configuration.
Steps:
1. In the test management, for the test status "Fail Retest Required" needs to raise the defect message .
In my scenario we used ZMIN for defect incident configuration for BRF+ action profile usage .
so for BRF+, active the action definition ZMIN_STD_FIND_PARTNER_FDT in ZMIN_STD action profile
2.During the defect incident creation in test management using the category schema like shown below
3. For category schema creation go to SM_CRM -> service operation -> Categorization Schemas and create your own categorization schema depend upon requirement and make note . like show below SAP Solman support category id: CA_11
4. Check the BRF+ configuration document- Support Team Determination via Business Rule Framework plus - SAP IT Service Management on SAP Solution Manager - SCN Wi…
After completing the 5.3 Create Decision Table in step 3.Choose the parameter CATEGORY from the query results.
follow the step in the BRF+ configuration document , in define the category id and support team details in the table contents
for support team creation go to SM_CRM -> service operation -> Organization Model
After completing all the steps in the document, active the schema.( for every change needs to re-active the schema for reflection)
Step:5 After filling all the details in the defect incident creation and click "OK".
Now automatically the defect incident is created and support will get mail notification for processing.
Hope this blog will help you in some extend to configure the Support Team Determination via BRF+ using category id in the defect incident (Test management)